Racine Roof Pros provides professional flat & low-slope roofing in Racine, WI for residential and commercial properties across the Racine and Kenosha lakeshore. Before we price a low-slope roof in Racine we cut a core out of it. Two inches square, straight through the assembly, so you and we can both look at the insulation and find out whether it is dry. Nothing else about the decision matters until that question is answered.
The reason is that a recover, meaning a new membrane laid over the old one, is the default recommendation in this trade because it is cheaper and quicker. On a wet assembly it is also permanent damage. You have sealed water into the insulation with no route out, and on this shore there is no summer dry enough to drive it back through. Core cuts settle it in twenty minutes.
Dry insulation means a recover is honest and we will quote it that way. Wet insulation means tear-off, and we will hand you the sample instead of asking you to take our word for it. When the readings land somewhere between, we take more cores and map the roof, and often we can tear off one section and recover the rest. There is a real membrane trade-off here that usually gets glossed over.
A white reflective sheet runs cooler than a dark one, which is precisely what you want in Phoenix and a mixed blessing on a lakeshore, because a colder surface condenses more on cool humid nights. That is not a reason to avoid TPO, and we install a great deal of it. It is a reason to stop treating reflectivity as free performance in a climate whose problem is drying rather than heat.
It is a reason to build the assembly properly underneath it. A vapor retarder placed for this climate, tapered polyisocyanurate carrying genuine slope to the drains rather than a nominal quarter inch, and staggered board joints throughout. We use 60 mil fleece-back TPO on most residential low-slope work and two-ply modified bitumen wherever foot traffic is heavy. Fasteners and plates get spaced for the perimeter and corner zones rather than one spacing across the whole field.
Ponding is the other local issue, and it hurts more here than the rainfall totals suggest, because standing water on a cool shaded roof simply does not evaporate away. Anything still holding water forty-eight hours after rain gets fixed with tapered insulation or an added drain, not noted in a report and forgotten. We flag it in writing with the depth measured, so if you decide to wait a year the decision is yours and it is documented.
Our licensed and insured team brings the right materials and equipment to every job — hand-sealed shingle tabs set in spots of asphalt roof cement, pin-type moisture readings logged on the deck bay by bay, 1x6 plank sheathing laid with open gaps between boards, core cuts taken through a low-slope assembly to check the insulation, an above-sheathing airspace on a batten and counter-batten grid, two-piece counterflashing set into a ground-out mortar reglet — and backs the work with a written workmanship warranty. We serve Racine and nearby communities including Mount Pleasant, Caledonia, Kenosha, Pleasant Prairie.
What We Handle
Everything our flat & low-slope roofing in Racine covers
One crew, one point of contact, and the full range of flat & low-slope roofing work in Racine, WI. If it is on this list we do it in house rather than handing it to a subcontractor:
- flat roof racine
- low slope roofing racine wi
- tpo roof installation racine
- epdm rubber roof racine county
- modified bitumen roof racine wisconsin
- flat roof leak repair racine
- tapered insulation roof racine wi
- flat roof recover racine
- roof core sample racine
- ponding water roof repair racine wi
- flat roof replacement racine
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Racine services.
Materials, equipment and how we do flat & low-slope roofing
The difference between flat & low-slope roofing that lasts and flat & low-slope roofing that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with hand-sealed shingle tabs set in spots of asphalt roof cement, pin-type moisture readings logged on the deck bay by bay, 1x6 plank sheathing laid with open gaps between boards, core cuts taken through a low-slope assembly to check the insulation, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Racine job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in the Racine and Kenosha lakeshore means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do flat & low-slope roofing outside Racine
Racine Roof Pros covers Racine and the surrounding communities of the Racine and Kenosha lakeshore. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Flat & Low-Slope Roofing in Mount Pleasant, WI — Racine County, population 27,732
- Flat & Low-Slope Roofing in Caledonia, WI — Racine County, population 25,361
- Flat & Low-Slope Roofing in Kenosha, WI — Kenosha County, population 99,986
- Flat & Low-Slope Roofing in Pleasant Prairie, WI — Kenosha County, population 21,250
- Flat & Low-Slope Roofing in Burlington, WI — Racine County, population 11,047
- Flat & Low-Slope Roofing in Somers, WI — Kenosha County, population 8,402
Start on the Racine Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Racine Chooses Racine Roof Pros
- ✓We take a moisture reading on the north slope before we quote, because the March number is the one that tells you what the deck has actually been living with
- ✓Any tear-off we install before the middle of May gets its field tabs hand-sealed, because a lakefront spring does not deliver the surface temperature a factory sealant strip needs
- ✓Every coating and sealant proposal carries a written dew point limit and substrate moisture limit, and we reschedule rather than spray when the numbers are wrong
- ✓No recover over an existing low-slope roof without a core cut first, and we hand you the core rather than describing it
The standards behind flat & low-slope roofing
Quality here is not a matter of opinion — it is written down. The flat & low-slope roofing work we do in Racine follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every flat & low-slope roofing project in Racine gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free flat & low-slope roofing free estimate in Racine, or request a quote and we'll get right back to you.